Key Performance Benefits100 to 288Vac Input Window — The rectifier holds the load on utility supply across a wide band, so weak branch feeds do not force repeated battery transfers.125 Percent Overload for 10 Minutes — Startup surges from LED screens, ATMs and vending equipment are ridden through instead of being pushed onto bypass.5.4kW from a 6kVA Frame — A 0.9 output power factor gives the frame more usable kW than the previous generation at the same VA rating.Online Double Conversion — Connected equipment receives a regenerated sine wave with voltage and frequency regulated at the output, independent of the incoming supply.Adjustable Battery Blocks — A no neutral battery design allows 16, 18 or 20 blocks, so runtime can be matched to the branch autonomy target.ECO Mode up to 99 Percent — Where the local grid is stable, the operating mode can be selected to reduce conversion losses during normal hours.2.8 Inch Graphic LCD — Status and measured parameters are visible at the cabinet, which supports routine inspection without additional software.Tower Footprint Reduced — Cabinet volume is 25 percent smaller than the previous generation, which matters where a branch room also holds racks and security equipment.Technical SpecificationsTechnical IndicatorSpecification Detail (GXE2 6kVA)Rated Capacity6kVA / 5.4kWTopologyOnline double conversion, tower formatInput ConfigurationSingle phase, 220/230/240Vac, 50/60HzInput Voltage Range176 to 288Vac at full load, linear derating to half load at 100VacInput Power Factor0.98 or higher at full load, 0.96 or higher at half loadOutput Power Factor0.9, crest factor 3 to 1Efficiency93.5 percent at full load, up to 99 percent in ECO modeOverload Capability125 percent for 10 minutesBattery Configuration16 blocks standard, 18 or 20 blocks selectable, no neutral designParallel CapabilityUp to 3 units in parallel for 2 plus 1 redundancyInterface and Monitoring2.8 inch graphic LCD, OT terminal blocks, optional monitoring cardsCertificationTLC, CQC and CEGXE2 6kVA: Protection Sized to the Branch, Not the Data HallBranch sites rarely fail because of a single dramatic event. They fail through a sequence of small supply disturbances.A voltage sag during a storm, a generator transfer that runs long, or a compressor start that pulls the feeder down for two seconds.Each of those events is enough to drop a POS terminal, an ATM cassette motor or an LED controller into a reboot cycle.The Vertiv Liebert GXE2 6kVA is dimensioned for exactly this class of load, not for a raised floor data hall.Its 100 to 288Vac input window means the rectifier keeps working through the low voltage conditions that would send a narrower unit to battery.Battery transfers are therefore reserved for genuine outages, which directly extends the service life of the battery string.The 125 percent overload rating for ten minutes covers the inrush current of motor-driven retail equipment without transferring the load to bypass.At the output, double conversion regenerates voltage and frequency, so equipment rated for 220Vac sees a stable supply regardless of the branch feeder condition.A 0.9 output power factor yields 5.4kW of usable capacity, and the cabinet is 25 percent smaller than the unit it replaces.For retail chains, banking networks and telecom access sites, the GXE2 6kVA converts an unstable branch supply into a defined power environment. The wide input window preserves battery runtime for real outages, the ten minute overload window absorbs motor startup, and the no neutral battery design allows 16, 18 or 20 block strings to be matched to the required autonomy. Standard TLC, CQC and CE certification supports procurement approval, while the 2.8 inch LCD keeps local inspection simple. For distributed estates with hundreds of small sites, this is the specification that keeps protection cost proportional to the load actually being protected.Technical FAQQ: Does the wide input range remove the need for a stabiliser at a weak branch site?A: Within the stated window the UPS regulates the output itself; a separate stabiliser is generally unnecessary unless the supply falls outside those limits.Q: Can the battery block count be changed after installation?A: The 16, 18 and 20 block options are selectable configurations; the change should be made with the battery string reviewed against the revised charge voltage.Q: Is parallel operation available on the 6kVA rating?A: The GXE2 series supports up to three units in parallel for 2 plus 1 redundancy, subject to the parallel kit and configuration ordered.

Our warehouse is located in the core logistics area with convenient transportation, covering an area of 1000 square meters, designed specifically for efficient, safe, and convenient storage and distribution.

There are brand new UPS (uninterruptible power supply), precision air conditioning, and various types of telecommunications power products from brands such as Vertiv, Huawei, Eltek, and Delta in the warehouse, as well as base station and data center equipment. These products are stored properly under intelligent management and environmental control, ensuring that every customer can receive the highest quality and most reliable products.

Whether it is large equipment or small electrical products, there are strict quality inspections and records at every step from warehousing to outbound, ensuring the safety and cycle management of goods.

In addition to efficient warehousing services, we also provide comprehensive logistics distribution, covering multiple transportation modes such as sea, land, and air, ensuring worry free storage and instant delivery of goods.